Midwestern Members - Anyone want to make $300?

My local shop wanted $450-500 to install my clutch, corvette tax maybe? Anyway i figured if someone from around here (willmar, MN) wanted to do the job for me i would pay them $300. thanks
-Cass

I used to live in Chaska, but now live in the sticks by Duluth. I would have man sorry. Good luck.

$450 is a good price, with headers its more then that. That's the going rate if not higher here...

Gotta remember, shoptime these days is going for A bill an hour.... Something tells me your tranny isnt easy to do either, but I am a moron when it comes to corvettes.

Vettes are more difficult man. $450 is about on. Low side if you ask me. You have to remove the rear end, exhaust, torque tube, trans...Not easy and very time consuming.

how much will it cost if someone screws it up, you think private parties warranty work? Spend a little more and have some peace of mind.

how much will it cost if someone screws it up, you think private parties warranty work? Spend a little more and have some peace of mind.

:judge:

Vettes are more difficult man. $450 is about on. Low side if you ask me. You have to remove the rear end, exhaust, torque tube, trans...Not easy and very time consuming.

I found out today that it is a 9.1 hour job so $450-500 is pretty good. Looks like i will just bite the bullet on this one!

I just did one last week and this week, so if you need one done let me know. We can schedual ya in and get ya taken care of. We usually recommend a slave cylinder at the same time too!