TB porting question
#1
12 Second Club
Thread Starter
Join Date: Mar 2003
Location: jonesville, MI
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
TB porting question
I am going to port/polish my own throttle body, but I have a question about the area near the throttle plate...the flat area that is not part of the bell shape. I realize that you don't want to create a gap between plate and casting at closed throttle, but should I avoid taking off much material in that flat part? It looks like it would effect slight throttle alot if you were to take off much material here. Does anyone have any ideas on this?