turkey

A friend of mine just picked up a set for his TA. I know they were made by Agostino Racing Engines and ARE was one of the premiere LS1 shops, but thats all I know.
I told him to have the heads flow tested and find out the size of the cc and runner, but he said he just wants to bolt them on and see where it ends up.

I'm not going to be able to convince him otherwise so for my own knowledge I wanted to know are these heads any good for a stock cube with a moderate cam?
Does anyone know approximate flow #'s?

Any comments on them overall good/bad/otherwise?

99blancoSS

iTrader: (115)

stage 3 generaly arent for a 346 unless its a dedicated race car. Huge cam leaving off the line at 4000 rpms and gears to match. Full blown drag suspension.
Usually the runners are huge and the upper lift flow numbers are big.
In a daily driven 346 it has potential to be a dog among dogs with a big cam no gears and full weight.

turkey

Thanks for the input, anyone else have any info?

venom ws7

iTrader: (13)

My friend ran Patirot Stg 3 heads on 346ci engine with Xtrem cam from comp cams
made 432rwhp 410rwtq the car was a monster at high rpm.

turkey

Does anyone have experience with Augostino heads? Or are they the same as/comparable to anything currently in production?

quiet_storm98

iTrader: (48)

hit up 02SOMWS6 he has the same heads and his car puts down over 450rwhp with a lil 224/228 cam and an aftermarket rear...his car was in gm hightech perfomance not to long ago http://www.gmhightechperformance.com..._trans_am.html