Dynamometer Results & Comparisons - Dyno'd the new setup

Well I installed some LS6 heads I got off here that I sent to TSP for CNC work. I got a 230/236 cam off a member on here also and a LS6 intake. Previous dyno numbers were 323hp/333lb-ft. I went out yesterday with the new setup and made a few more pulls to see where I stand. Car made 410hp/385lb-ft. I was hoping for a little more, so i'll have to finish the free mods and bolt ons. Next up is an under drive pulley, ported TB, and a better y-pipe/cutout setup.

Do these numbers seem about right?

William

p.s. Forgot to mention the heads were milled to 61cc and I'm running a cometic .040 gasket (compression should be around 11.5:1 static).

Sounds like a good start bro.

Considering the mods you have, thats about right.

Dont mind the dyno glitch, here's the graph.

http://img213.imageshack.us/img213/802/newdynopt0.jpg

William

Will, do you have happen to have the SAE numbers as well?

Looks good.

No I do not, I can call up and ask for them as I need to get the datalog files anyway.

William

Cool, if you have the actual dynojet file you can convert all the numbers as well.