marxcamaro

I have already figured out the max flow rate for the turbo engine that I will be building. If one is going to use a twin turbo application would you divide the MFR in half when you are looking up your #'s on a compressor map for a specific turbo? Sorry if this is a stupid question, but I couldn't find a specific answer when I did a search. Thanks in advance for any information in this matter!

DrTurbo

iTrader: (3)

This will help


http://www.forcedinductions.com/help.htm

ddnspider

iTrader: (26)

ie for twins use same pressure ratio but half the lb/min

marxcamaro

Thanks for the information guys. I am trying to learn as much as possible by reading and researching. I am a NA guy so this stuff is new to me.