Oil Pump schim?
#1
TECH Apprentice
Thread Starter
iTrader: (2)
Join Date: May 2005
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
Oil Pump schim?
I was going to get a LS4 oil pump for my ls1 but after reading a few post, Not so sure. I wanted to cut a small schim for my stocker just to boost the oil pressure a tad. Does anyone know how the deminsions this schim has to be? I looked at SLP's version and it seems like it would be very easy. I plan to get an aluminum rod of that size and just cut a piece off the end. What are your thoughts?
This would cost under $5.00. Is it worth it?
This would cost under $5.00. Is it worth it?
#3
11 Second Club
iTrader: (3)
Originally Posted by flynlow3
I was going to get a LS4 oil pump for my ls1 but after reading a few post, Not so sure. I wanted to cut a small schim for my stocker just to boost the oil pressure a tad. Does anyone know how the deminsions this schim has to be? I looked at SLP's version and it seems like it would be very easy. I plan to get an aluminum rod of that size and just cut a piece off the end. What are your thoughts?
This would cost under $5.00. Is it worth it?
This would cost under $5.00. Is it worth it?