1slowZinthe513

iTrader: (10)

factory m6 lt1's have a rev limiter right? so when you hit 5500-6000 rmp does it boggle down or something? my z use to be an a4 and is now a m6 with an a4 computer and i have taken it to 6000 rpm.. really dont want to be doin that

ThoR294

iTrader: (6)

mine rev limits at about 6grand.

94greencamaro

iTrader: (8)

if you dont want to be doing that dont rev it so high
or go get some tuning software and set the rev limiter wherever you want it

3pnt4maro

iTrader: (2)

i got mine set at 5800..you got stock heads so i would say 5800 sounds about right

1slowZinthe513

iTrader: (10)

I didnt mean to rev it that high.. Im just not that use to it being a manual...

Software: i wouldnt have to go as far as getting lt1 edit or something just to make a rev limiter would i?

ZONES89RS

iTrader: (25)

Get batter at shifting, i hit my rev limiter on purpose to see what is sound like spinning the tires.

transamws6_97

iTrader: (5)

why in the world would you need to hit the rev limiter to spin your tires?

ZONES89RS

iTrader: (25)

No, instead of feathering out the throttle while spinning to try and hook up i just smashed it to see when it hit the limiter and how it would sound, trust me, i would never hit it without a load on it intentionally. I was allready moving, just not sticking to the ground, hell i didnt even dump the clutch to get it to start soinning.

transamws6_97

iTrader: (5)

oh ya i know what you mean now...i got 4.10s you know how easy it is to spin and tap that limiter in 1st.. even w/ mine set at 6500 (don't ask me why came that way when i bought it) it gets up there quick i try to watch it and keep it below 6k tho

Ironxcross

iTrader: (8)

mine hits the rev limiter around 6300 or so. well its probably 6k, but the tach reads high.

94greencamaro

iTrader: (8)

yeah you would have to buy software, or a programmer. you have to flash the pcm somehow. i would say just get used to it and you should be fine

Formula350

iTrader: (3)

I think 5,850 is the stock limiter. My friends 94 Vette M6 seems to bounce off the limiter there as well, so I don't think A4 and M6 have a different limiter RPM.

Some people here I think go 6K on their stock motor and haven't had a problem.

My tach is right on up to 4K rpm. I haven't tested above that though. I don't feel like slowing bringing it up to 5500 so I can watch my scanner heh. And bringing it up fast means I have to drive fast, and I'd rather keep my eyes on where I'm going then.

ZONES89RS

iTrader: (25)

Yea, i had to use the $$$ i had for a whole 10 bolt built with 4.10s for a used opti that turned out to be bad....fuggin suxxxxx.