Forgive my Ignorance
08-28-2007, 08:06 PM
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Jun 2003
Location: OKC,Oklahoma,USA
Posts: 81
Likes: 0
Received 0 Likes
on
0 Posts
Forgive my Ignorance I just order my MTI intake lid and the sensor hole wasnt drilled. i left it off and it through an SES light im kinda pissed about it. so what do you think send it back. drill the hole. can i just leave it off and turn the code off whats up? here are pics of what im talking about
sorry this pic was takin with my cell phone. but you can see the blue end plug in that doesn have a home anymore
sorry this pic was takin with my cell phone. but you can see the blue end plug in that doesn have a home anymore
cheaper than sending it back. It's no big deal, just drill it out.
08-29-2007, 12:53 AM
#6
TECH Addict
iTrader: (1)
Join Date: May 2007
Location: NY
Posts: 2,516
Likes: 0
Received 0 Likes
on
0 Posts
You can leave it out and clear the code but it's going to keep tripping it as long as that remains unhooked plus your car might not run right. Just drill your hole and put it back in there.
Trending Topics
08-31-2007, 02:19 AM
#8
TECH Apprentice
iTrader: (16)
Join Date: Jan 2006
Location: Tulsa OK
Posts: 372
Likes: 0
Received 0 Likes
on
0 Posts
You do need the sensor. Its how the PCM knows the temperature of air coming into the intake.
My SLP lid came with the proper holes, never would have thought any of them wouldn't.
The stock lid should have a little rubber gromet you will want to drill your whole big enough to ue that again.
My SLP lid came with the proper holes, never would have thought any of them wouldn't.
The stock lid should have a little rubber gromet you will want to drill your whole big enough to ue that again.