slowjoe99

iTrader: (7)

I want to get my stock throttle body ported to get it ready for the H/C i'm putting in. Where do i take in to get this done?? how much should it cost?

95 Z28

iTrader: (21)

I had smokin87ta (I think that's his name) do mine and it looks awesome. Shaner, and Bo White also do great work.

LS1Z28-00

iTrader: (8)

price for one is usually 50-75$ well worth it though.

transam45

iTrader: (2)

transam45 does good work

svodave

Does look very good. Do you "knife edge" the b-fly valve though? Looks flat in pic.

greysteel_M6

iTrader: (5)

/\ Never heard of knife edging the plate, seems like it would be a lot of work and worth what? .01hp

transam45

iTrader: (2)

i dont knife egde but i can if you want it done there not realy any power to made from doing that plus you run resk of causeing bad idle problems if you mess up "the b-fly valve" what u mean ?

here another pic but i painted this 1

transam45

iTrader: (2)

this is a stock 1 the main housing is were most of the modifaction is to be done for the most power

svodave

It's not much work. I just took a permanent marker around the leading edge and took it to the grinder. Leave a trace of that marker and that way you know it's still round and should still idle fine. Takes a few minutes since it's taken all apart anyway.....and yes, it probably makes .01 hp.

nick1ta

is there any write-ups on exactialy how to do it?