SES Light with epoxied throttle Body
#1
TECH Fanatic
Thread Starter
Join Date: Jul 2002
Location: MI
Posts: 1,218
Likes: 0
Received 0 Likes
on
0 Posts
SES Light with epoxied throttle Body
I took my throttle body off last night, put epoxy in the gaping hole in the top of it(used straws to keep the passages for the cruise control and the line that goes off the back...I can't think what it is off hand). I did not dremel the TB. I left ring of material close to the blade on the TB because I didn't have enough time to do the whole thing. Anyway, after contouring the epoxy to the shape of the housing, I put it on the car and started it up- ran fine except for a little low idle (relearning) and drove it home that night about a mile and a half. Today I took it out and got a carwash, after starting it at the carwash I found the Service Engine Soon light staring me right in the eye. I drove around about thirty miles tonight with it on and no problems. What could this be. I don't like the fact that it is always on because if something does really go wrong with the car, I would like to know. Thanks, -Mike
#4
10 Second Club
iTrader: (1)
Re: SES Light with epoxied throttle Body
you replied to one of my post in the kill section called poor little z06.you seemed to dought that flint had 50 to 150 cars going in one spot.well last night we ran from 10.00pm to 2.20am with 150 to 200 cars and no cops till 2.20am.me and my bud video taped alot of bad *** races and how many cars were there. when the tape is full we will make a video so yall can watch.if you ever come up to run let me know it would be cool to meet with ya. mike c.