vetteboyc5

iTrader: (9)

Help me please.

I did a headswap on my ls1. Engine fired right up and whatnot runs smooth,..

Howecer- On the Left bank the lifters are totally raiseing hell, I figured Id let the car run, I let it run for 10 minutes and Its still very loud..

Is there anytrhing I could have done wrong?

I used Some trickflow 7.400 Pushrods. they are rounded at the ends, but The only Thiing I noticed was that the stock ones have a ball o the end, These are are one piece, They assured me this didnt matter...

Anyone?

vettenuts

iTrader: (4)

Responded on CF, need more information on what was done while the car was apart.

2000Hawk

iTrader: (5)

What does the noise sound like exactly? As stated above was anything else other than the heads done?
-Joel

1320 killer

iTrader: (6)

=1 for the above. let us know exactly what else was done besides the heads.

427

iTrader: (3)

Did you check valve clearance with the new heads?

Kurt

vettenuts

iTrader: (4)

One of your other threads on CF mentions an over-rev and bent valve, did they remove and verify all valves were straight? If they didn't and the valve is not fully closing, then the height of the valve stem will be slightly reduced and you get the ticking sound.

GuitsBoy

iTrader: (4)

+1 for 427 and vettenuts replies. Did you check both issues properly?