Conversions & Hybrids - Where did you get your LS1 pullout? (again)
12-09-2007, 01:48 PM
There was a thread titled something like this but I can't find it now. I reformatted my harddrive a week ago and forgot to write down my bookmarks, so I lost them. Now I can't seem to remember the few sites I had that sold pullouts. One was cleveland pick-a-part, another was tacreationsusa.com. I can't think of any of the others. I'm going to be ordering my ls1/t56 pullout tomorrow so any more sites/phone numbers would be great.
12-09-2007, 02:21 PM
I used cleveland pick a part and was real happy with them. There is a place called Schram Auto Parts in Michigan and a place called F-Parts that I believe is in Western Pennsylvania. The best bet to search on LS1 on Ebay.
12-09-2007, 02:38 PM
i used F-parts
12-09-2007, 04:21 PM
Found mine thru carparts.com. Was about 30 min. from my house.
12-09-2007, 04:59 PM
y not look into a 6.0 based engine?
they weigh like 70 lbs more than the alloy block, but they have a larger bore
and can be over bored to .030=370ci
someone will always need the 317 heads for fi, so u can sell those and get some cash back if not used,
i would recommend u rebuild the 6.0 and t56 so u can start out with a frsh start as opposed to using stuff u prolly got from enthusiasts that has been
banged on and raced:D
12-09-2007, 05:01 PM
try scouring local junkyards, and since it holiday season, they are usually
more prone to part with at cheaper prices, at least in my exp. this has been the case
vBulletin® v3.7.4, Copyright ©2000-2013, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO