Milled .030 - Will there be a P/V Issue with this cam ???
06-27-2003, 01:15 PM
#1
TECH Enthusiast
Thread Starter
Join Date: Dec 2001
Location: Texas
Posts: 601
Likes: 0
Received 0 Likes
on
0 Posts
Milled .030 - Will there be a P/V Issue with this cam ??? I'm going with a 224/224 563".563" on a 114 (Thunder Cam).
Thunder doesn't email me back so I'm hoping you guys can answer this question. Also what size push rods should I get - 7.350 or 7.400. I have Absolute Speed 1x heads milled approximately .030.
Thanks in advance
Thunder doesn't email me back so I'm hoping you guys can answer this question. Also what size push rods should I get - 7.350 or 7.400. I have Absolute Speed 1x heads milled approximately .030.
Thanks in advance
06-27-2003, 01:44 PM
#4
TECH Apprentice
Join Date: Feb 2002
Location: tega cay, SC
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
Re: Milled .030 - Will there be a P/V Issue with this cam ??? why does he need the 7.35 pushrods? i have a T1 with .558 lift and ls1 heads milled .030". i'm pretty sure i still have 7.4 hardened pushrods.
