Northwest Members - Who around here, can mill my heads???

Just like the title says...

Is there someone around here that can do it? And what are there prices, wait time, and phone number?

Lane

tsp can do it for 75 bucks prob take a week or so......and yes i know not local just an alt choice

C&D in Kirkland did mine. ~Guy

C&D in Kirkland did mine. ~Guy

What did they cost?? You can send me a pm if you don't want to put it on here!!!

I think it was around 100.00 for the resurfacing (milling) I also had them CC'd so it was like 120 or so alltogether. Id just give them a call. I think hes open tomorrow. ~Guy

Lane, just take them to F&S in town. He did mine a while back and they were fine. He repaired one of the valve seats and milled em like .007" to resurface them and only charged me around 100 bucks. He even setup the springs on them afterwards and all for just 100 bucks.

Well I just got of the phone with XL8RN, And they are 4.8 heads, He was cleaning them up and seen the casting on them. Witch is fine, I did some research on them, they have a 62cc, and flow the same as a 5.3. So I don't think I am going to mill them.

But I am still going to use Cometics, and go on ahead and fly cut.

My CR should be around 11.1:1. Witch is fine.

You know the 4.8 heads have smaller valves don't ya?

They haeve 1.89, stock. But these have the 2.00 They still have flow ovr 300 and .600 So I think they will be okay...