95GreenZ28

iTrader: (70)

I need some help here guys I installed a ls1 into my 95 Z. I need to get the fuel hooked up so I can drive this car finally. I put a 99 vette filter/regulator where the stock filter goes. I have the line to the front connected already. I need help on how and what to run to the feed and return side from the tank to the filter/regulator. Anyone able to help me out here? Thanks in advance!

LS1GMCTruck

iTrader: (2)

You have to have a return fuel port connection at your fuel tank. Connect this to the return nipple on the Vette regulator/filter. Its labeled on the regular, which is return & which is fuel supply(in).

67rsss

iTrader: (4)

The 3/8 is the input to the filter/regulator and the 5/16 is the return to the tank.

95GreenZ28

iTrader: (70)

I know which is which I am asking how do I connect my lt1 quick connect to the 3/8 vette regulator

67rsss

iTrader: (4)

Good question. Wish I had the answer.

95GreenZ28

iTrader: (70)

Thanks for looking though man!

Shon Herron

iTrader: (25)

If it's routed to the tank, yep!

95GreenZ28

iTrader: (70)

?? I am asking what type of fitting is needed to connect the two.

LS1MCSS

iTrader: (18)

What type of connection, if any, does the original line have on it?

Shon Herron

iTrader: (25)

if you are using the stock LT1 fuel rail connections on the filter/reg and trying to connect it to the stock plastic lines then you can get the part needed from Advance Auto. It's in the fuel repair section.

95GreenZ28

iTrader: (70)

Thanks Shon

AnniversaryZ28

iTrader: (5)

I think i am going this route for my swap, i am still waiting on an answer regarding it bolting to a stock intake.

http://cgi.ebay.com/ebaymotors/97-98...spagenameZWDVW