ok clear this up plz C/R issue
07-19-2003, 03:41 PM
#1
*Bad Trader*
Thread Starter
Join Date: Nov 2001
Location: here and there
Posts: 1,459
Likes: 0
Received 0 Likes
on
0 Posts
ok clear this up plz C/R issue if im not mistaken, 5.3 heads milled .015 gives right at 11.1-1 CR with 2.00/1.56 valves, im quite sure on this, but maaaaaaybe im wrong here......plz dont speculate, only if you 110% sure post, theres alot of misinfo going around on this topic.... 
07-21-2003, 03:17 PM
#4
Launching!
Join Date: Jul 2002
Location: pa
Posts: 246
Likes: 0
Received 0 Likes
on
0 Posts
Re: ok clear this up plz C/R issue
well....I KNOW a 60 cc chamber on a stock 5.7L shortblock (01 LS1) with the factory gasket makes 11.1:1 CR.....so...work from there....
07-21-2003, 07:45 PM
#5
Re: ok clear this up plz C/R issue
well....I KNOW a 60 cc chamber on a stock 5.7L shortblock (01 LS1) with the factory gasket makes 11.1:1 CR.....so...work from there....
really.......hmmm....whats the thickness of a Felpro gasket vs. the stock (I think stock is 0.050" crushed right?) and where can I get one.....that might be a good little upgrade
07-21-2003, 07:57 PM
#6
Launching!
Join Date: Jul 2002
Location: pa
Posts: 246
Likes: 0
Received 0 Likes
on
0 Posts
Re: ok clear this up plz C/R issue
well....I KNOW a 60 cc chamber on a stock 5.7L shortblock (01 LS1) with the factory gasket makes 11.1:1 CR.....so...work from there....
really.......hmmm....whats the thickness of a Felpro gasket vs. the stock (I think stock is 0.050" crushed right?) and where can I get one.....that might be a good little upgrade
Trending Topics
07-22-2003, 12:01 PM
#9
TECH Fanatic
iTrader: (1)
Join Date: Nov 2002
Location: Venice, Ca
Posts: 1,829
Likes: 0
Received 0 Likes
on
0 Posts
Re: ok clear this up plz C/R issue Napa auto parts carries them. I would try a parts store rather than a sponsor because it would probably be a little cheaper.