Automatic Transmission - 4L80E pigtail source




View Full Version : 4L80E pigtail source


GrahamHill
03-24-2008, 08:56 PM
Are there any places selling 80E pigtails reasonable? It doesnt even have to be a conversion pigtail... Just the plug and enough wire to get started..


GrahamHill
03-25-2008, 01:17 PM
...and does anyone have pic of their floor after hammering on it so I can start before the first try?

382ssz28
03-26-2008, 01:48 PM
No pictures but Transtar has early and late pigtails. They are AC Delco and Rostra brands. They have many depots in the country so look one up close to you. Good luck.


nahasapeemapetalon
03-26-2008, 03:06 PM
What area are you referring to, area where electronic plug comes out of driver side 4l80e? It will need to be cut, i can post pics later once i load them.

1hotls1
03-26-2008, 03:17 PM
Call Speartech. I got my conversion from them, but I'm sure they sell just the plug with some leads.

GrahamHill
03-26-2008, 04:13 PM
Im trying to dodge the premium they charge for their harness. Im sure its a nice piece though.

GrahamHill
03-26-2008, 04:14 PM
What area are you referring to, area where electronic plug comes out of driver side 4l80e? It will need to be cut, i can post pics later once i load them.

Nah, mainly on the floor and firewall that needs to be beat out for the bigger 4L80e to fit in my fbody.

Any pics would be GREATLY appreciated!

GrahamHill
03-26-2008, 04:22 PM
No pictures but Transtar has early and late pigtails. They are AC Delco and Rostra brands. They have many depots in the country so look one up close to you. Good luck.

Completely out :(

Thanks for the tip though! I'll try them back again in a few weeks!

SUPERBOOST
03-26-2008, 05:02 PM
lNah, mainly on the floor and firewall that needs to be beat out for the bigger 4L80e to fit in my fbody.

Any pics would be GREATLY appreciated!

You dont have to beat out the floor or firewall to install the 4l80e.You do however have to cut out a section of the floor pan brace where your electronics plug into the transmission.Not through the floor,just the brace.You really need to cut ot another section where the rear trans line comes out of the trans,its very tight there.Nahasapeemapetalon,(above post) has some good pictures of this if he will post them for you.Also you have to cut off the ears on the trans to clear the floor.

GrahamHill
03-26-2008, 05:55 PM
Thanks soooo much!

GrahamHill
04-16-2008, 04:55 PM
I got one from a local junkyard for 20 bucks!