help?
#1
Teching In
Thread Starter
Join Date: Jan 2008
Location: Edmonton, Alberta, Canada
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
help?
I have a 2002 ls1. I currently installed the ms3 cam and 5.3 ported heads. I also ran their hardened 7.4 inch pushrods. my question is, i also used the felpro 1041's which run a .041 thickness. i have not ran the engine yet, but do you think i'll have ptv issues? I installed the cam in dot to dot. I might tear it down and fire the factory gm ones in. So far just by turning it over it looks like i have lots of room. Anyone run this setup yet?
#2
11 Second Club
iTrader: (27)
Join Date: May 2005
Location: Your girl's back door giving her the long stroke while you're at work
Posts: 6,801
Likes: 0
Received 3 Likes
on
3 Posts
I'm running it right now but I have forged pistons with valve reliefs.
Pull the head and check the PTV, not that hard and won't take a lot of time. Better safe than sorry
Pull the head and check the PTV, not that hard and won't take a lot of time. Better safe than sorry