LS1TECH - Camaro and Firebird Forum Discussion

Generation III Internal Engine 1997-2006 LS1 | LS6
Sponsored by:
Sponsored by:

Rockers question

Thread Tools
 
Search this Thread
 
Old 04-19-2008, 09:39 AM
  #1  
Teching In
Thread Starter
 
Cmhatter9SS's Avatar
 
Join Date: Jan 2008
Location: Eastern PA
Posts: 39
Likes: 0
Received 0 Likes on 0 Posts
Default Rockers question
I am getting some new rockers, pushrods and springs for my car right now on stock cam. But is my best Bet you think?
Cmhatter9SS is offline  
Reply Like
Old 04-19-2008, 12:48 PM
  #2  
TECH Senior Member
iTrader: (4)
 
vettenuts's Avatar
 
Join Date: Jul 2004
Location: Little Rhody
Posts: 8,092
Likes: 0
Received 9 Likes on 9 Posts

Default
Are you just freshening the valve train, or setting up for an eventual cam installation?
vettenuts is offline  
Reply Like
Old 04-19-2008, 02:12 PM
  #3  
Teching In
Thread Starter
 
Cmhatter9SS's Avatar
 
Join Date: Jan 2008
Location: Eastern PA
Posts: 39
Likes: 0
Received 0 Likes on 0 Posts
Default
Setting up for eventual Cam
Cmhatter9SS is offline  
Reply Like
Old 04-19-2008, 03:35 PM
  #4  
TECH Senior Member
iTrader: (4)
 
vettenuts's Avatar
 
Join Date: Jul 2004
Location: Little Rhody
Posts: 8,092
Likes: 0
Received 9 Likes on 9 Posts

Default
What you may run into is the need to run bigger springs and a different length pushrod depending on cam and setup. I would wait that being the case. The YT rockers are a nice affordable setup though.
vettenuts is offline  
Reply Like
Back to Subforum
Generation III Internal Engine
View Next Unread
383 vs 408




Advanced Search

All times are GMT -5. The time now is 01:50 PM.