My "Bitchin Camaro" project
04-21-2008, 03:06 PM
#3
TECH Junkie
Thread Starter
iTrader: (12)
Join Date: May 2002
Location: Burleson/Ftw,Texas
Posts: 3,420
Likes: 0
Received 0 Likes
on
0 Posts
just the rods, im not gonna run anything more then a 200 shot(progressive at that) when im ready, Factory head bolts will be fine for that much.
04-21-2008, 03:22 PM
#5
TECH Junkie
Thread Starter
iTrader: (12)
Join Date: May 2002
Location: Burleson/Ftw,Texas
Posts: 3,420
Likes: 0
Received 0 Likes
on
0 Posts
stock head bolts your suppose to use the angle wrench, I wish I would have spent the money for ARP head bolts, the head bolts where a 2 man job cause of that angle wrench, One torquing and the other one watching the gauge.
Trending Topics
10-06-2008, 04:27 PM
#9
TECH Junkie
Thread Starter
iTrader: (12)
Join Date: May 2002
Location: Burleson/Ftw,Texas
Posts: 3,420
Likes: 0
Received 0 Likes
on
0 Posts
incase u guys dont make it to the Texas section, My 70 Camaro is up and running, link on the 1st post takes u to kinda whats going on and my cardomain link shows some pics of what has been done and whats gonna be done....enjoy
10-17-2008, 03:50 PM
#11
TECH Enthusiast
iTrader: (26)
Join Date: Jan 2006
Location: Western Section
Posts: 571
Likes: 0
Received 0 Likes
on
0 Posts
So you made a thread that was nothing but a link to a thread that is a link to another thread? Why didn't you just link the right thread from this one?
10-17-2008, 04:30 PM
#12
TECH Junkie
Thread Starter
iTrader: (12)
Join Date: May 2002
Location: Burleson/Ftw,Texas
Posts: 3,420
Likes: 0
Received 0 Likes
on
0 Posts
well on the old thread was some photobucketed pics that if u post one too many times shut down all your pics u posted....to cheap to upgrade my free photbucket account
