Which Pulley for stroker?
06-04-2008, 05:02 PM
#1
Launching!
Thread Starter
iTrader: (3)
Join Date: May 2004
Location: El paso, tx
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
Which Pulley for stroker? I just want to get some feedback on what pulley I should by for a stroker 383 LS1. Someone please help. Money not object, ATI, TCI or powerbond? everybody says different. PLEASE HELP
Last edited by shaulinmathvader; 06-11-2008 at 01:57 PM.
06-04-2008, 05:20 PM
#2
I'm using the ASP pulley in my 383 build, runs just fine. I dont think a pulley on a 346 vs. 383 makes a differance.
If your planning on supercharging the car though, I'd go with the ATI and pin it. That'll be one less step when its time for the FI.
If your planning on supercharging the car though, I'd go with the ATI and pin it. That'll be one less step when its time for the FI.
06-11-2008, 01:56 PM
#5
Launching!
Thread Starter
iTrader: (3)
Join Date: May 2004
Location: El paso, tx
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
Please Help OK guys someone please help. Im being told that a powerbond is better than a TCI pulley. Im also being told that ATI is best 4 harmonics. Plain and simple I just need someone's feedback on which pulley I should use for a 383 stroker that will get a 150 shot.
05-07-2009, 06:18 PM
#6
TECH Apprentice
iTrader: (8)
Join Date: Dec 2005
Location: Morris, IL
Posts: 395
Likes: 0
Received 0 Likes
on
0 Posts
Vader - What pulley did you end up going with? I'm in a similar situation right now. 416 stroker and an M6 tranny. I ran the ASP on my 346 for a couple of years but have read some horror stories about them on strokers with manual trans.
Thank you
Thank you
