L92 swap - wiring question
#1
TECH Fanatic
Thread Starter
iTrader: (9)
Join Date: Aug 2007
Location: Rocky Mtn thin air & snow...
Posts: 1,237
Likes: 0
Received 1 Like
on
1 Post
L92 swap - wiring question
Hey guys, I've just about gotten all of the old stuff pulled out of my car, & I've started looking at the new parts that I have - particularly the wiring harness & the DBW accelerator pedal. I've bought the engine harness from an '08 Yukon/Tahoe/Escalade, & the pedal from an '07 Vette.
Does anyone know whether the engine harness would have the accelerator pedal connector on it or not? (If it does, then I'm going to have to do some tweaking, since none of the connectors on the harness match up to the pedal...)
Also - does anyone happen to have a valid RockAuto discount code? (I sure wouldn't complain if I could save a couple bucks on my clutch master/slave cylinders...)
Thanks in advance all...
Does anyone know whether the engine harness would have the accelerator pedal connector on it or not? (If it does, then I'm going to have to do some tweaking, since none of the connectors on the harness match up to the pedal...)
Also - does anyone happen to have a valid RockAuto discount code? (I sure wouldn't complain if I could save a couple bucks on my clutch master/slave cylinders...)
Thanks in advance all...
#2
9 Second Club/LS1TECH Sponsor
iTrader: (14)
No, it's not part of the engine harness.
__________________
91 Z28 LS2 408CI, LS9 Supercharger, LPE GT7 cam, Yank3000, 3450 raceweight.
Latest numbers: 9.71 ET, 141.42 MPH, 1.40 60' , 610 RWHP Mustang Dyno
www.speartech.com
91 Z28 LS2 408CI, LS9 Supercharger, LPE GT7 cam, Yank3000, 3450 raceweight.
Latest numbers: 9.71 ET, 141.42 MPH, 1.40 60' , 610 RWHP Mustang Dyno
www.speartech.com