Midwest Fab. 9 & Strano Springs ?
#1
TECH Enthusiast
Thread Starter
iTrader: (13)
Join Date: Jan 2006
Location: Parkton, Md.
Posts: 658
Likes: 0
Received 0 Likes
on
0 Posts
Midwest Fab. 9 & Strano Springs ?
Does anyone run this setup? I was looking to see if there were any major clearance issues(T/A mount) and how the car sits (Level or raised in the rear). I expect to have to clearance the floorpan a little bit, which is not a big deal. I have the Strano springs but have not installed them yet, I am waiting to hear from someone that is running this set up. Thanks for any replys.
#2
TECH Junkie
iTrader: (2)
My car is lowered 1.5 inches and the midwest raises the rear 1/4 of an inch , but it is hardly noticeable. I remember one person chiming in with the midwest and strano springs and he did not have any clearance issues whatsoever. Either did I being lowered 1.5 inches. You should be fine and the 1/4" is not really even noticeable.
#3
TECH Enthusiast
Thread Starter
iTrader: (13)
Join Date: Jan 2006
Location: Parkton, Md.
Posts: 658
Likes: 0
Received 0 Likes
on
0 Posts
My car is lowered 1.5 inches and the midwest raises the rear 1/4 of an inch , but it is hardly noticeable. I remember one person chiming in with the midwest and strano springs and he did not have any clearance issues whatsoever. Either did I being lowered 1.5 inches. You should be fine and the 1/4" is not really even noticeable.