thunderstruck507

iTrader: (18)

I have a B&M megashifter in my car, with the engine/tranny moved back for this swap the tailhousing is interfering with the cable

what have you guys done to get it through?

I'm afraid to bend it much if any....I've broken 2 of these cables as is in the last 3 years

downset71

its a tite bend out of shifter ,thru floor and around tailpiece.i made the hole in floor a little bigger, looped it towards drivers floorboard, and clockwise around tranny mount with a tyewrap.runnin the same ls1/700 combo

SMAX

iTrader: (11)

You could just order a short cable and not have to loop it.

downset71

if the cable was shorter, it would bind up on the turns. thats the problem.the linkage is now to close to the shifter. its better to use a long cable.

thunderstruck507

iTrader: (18)

very true, last time mine broke I ordered 3 sizes from summit and sent the ones that didn't fit as well back

I believe mine is the 5 foot heavy duty one.