View Poll Results: Keep the bullets or remove to original set up?
Keep the bullets
2
66.67%
Take them Off
1
33.33%
Voters: 3. You may not vote on this poll
Exhaust Poll, Keep Magnaflow bullets or without?
#1
Exhaust Poll, Keep Magnaflow bullets or without?
Like it says, Notes- Mac mids, magnaflow cats, Flowmaster Y, LM1 , Magnaflow bullets, CME. The most complicated exhaust ever! AKA "Frankenhaust"
It's ok, but not as aggressive as it was without them. I was just trying to keep the levels down to keep from getting unwanted attention!
here they are
Pic
VID's
http://youtube.com/watch?v=RxGLpiY6tFU IDLE REV Without Bullets
http://youtube.com/watch?v=dFG9B0MS2V4 IDLE REV With Bullets
http://youtube.com/watch?v=c1rcQxUWHyo 1-3rd without Bullets
http://youtube.com/watch?v=3fvromMJLlI 1-3rd with Bullets
It's ok, but not as aggressive as it was without them. I was just trying to keep the levels down to keep from getting unwanted attention!
here they are
Pic
VID's
http://youtube.com/watch?v=RxGLpiY6tFU IDLE REV Without Bullets
http://youtube.com/watch?v=dFG9B0MS2V4 IDLE REV With Bullets
http://youtube.com/watch?v=c1rcQxUWHyo 1-3rd without Bullets
http://youtube.com/watch?v=3fvromMJLlI 1-3rd with Bullets
Last edited by driving; 07-28-2008 at 08:42 PM. Reason: Added notes
#4
11 Second Club
Join Date: Dec 2007
Location: Charleston, SC
Posts: 868
Likes: 0
Received 0 Likes
on
0 Posts
so wait ur runnin cats, a loudmouth and magnaflow muffler or am i missin somethin?
if so i say ditch the lm1 and run the magnaflows, and throw on a cutout for when u want it loud
if so i say ditch the lm1 and run the magnaflows, and throw on a cutout for when u want it loud
#5
TECH Regular
Join Date: May 2008
Location: Marissa, Il
Posts: 458
Likes: 0
Received 0 Likes
on
0 Posts
I think it sounds good in both sets of video. And the Tips have got to be my favorite!
#6
Yes cats flow Y, LM1 and magnaflow bullets. The video doesnt do just the LM1 justice. Bascally im looking for the same sound before i added the magnaflow muffs just a bit quieter on the the top end. I thought the magnaflows would take the edge off it, but they cut the sound levels in half. So trying to decide to leave em, take em off, or take em off and change the LM1 for a LM2 or Dynomouth set up.
#7
TECH Regular
Join Date: May 2008
Location: Marissa, Il
Posts: 458
Likes: 0
Received 0 Likes
on
0 Posts
I say even though it is a bit of work I would Have the lm1 resonator taken out and maybe have it set up with v-band clamps so you can exchange as your tastes change. after that you could have a few different setups made
that you could change as you wish without constatly cuting your exhaust up.
Maybe even have a n electric cutout put in place of the lm resonator so you could have total control.
that you could change as you wish without constatly cuting your exhaust up.
Maybe even have a n electric cutout put in place of the lm resonator so you could have total control.
Trending Topics
#9
Heavy maybe im just looking for the right combination.I did think about the V band thing to swap out muffs but would have to have a V-band welded on every muffler i try and that would kill the resale value.
#12
I prefer the more refined sound with the bullets. It would sound better a little louder, but everything is a trade-off.
blown03mustang has a point, you can have both with a cut-out.
blown03mustang has a point, you can have both with a cut-out.
#13
Cut out is too raspy, in my opinion. Looks like LM2 my be my next bet. Bullets make the car sound stock. Not bad but definitely not like a camaro should sound. Its like a truck, like a F-150 ford to be exact i started my car in the parking lot yesterday and then a guy started his Ford F-150 and swear it was the same. Gotta change it but not sure what too just yet.