ChicagoTransAm

Have a sticking purge valve... I pulled it apart partially (need to get a spanner wrench I guess). When I put the cover back on though... I can turn it from side to side. I don't want to go TOOO tight, but how tight is this supposed to be???? Seems I am putting in more turns than there was in the first place.

P.S. It's an NX Purge

69_YENKO

iTrader: (16)

the nut on the top just holds the coil in place on top of the plunger part of the noid it doesnt need to be super tight, i normaly just position the coil so the wires and label are facing how i want them to be then snug up the nut.

860 Performance

iTrader: (1)

I use locktite on that nut. Like 69 Yenko said, it dosen't need to be tight, but the locktite keeps it in place.

JoeyGC5

iTrader: (24)

One other thing is to make sure the pluger tube/shaft is tight in the valve body to prevent any leaks, as you've already found.

1badrz28

iTrader: (6)

These guys are correct.