Soul TKR

iTrader: (4)

Hey guys... I know I've seen em around but can't remember where... I'd like to setup my nostrils on my WS6 hood for a true CAI setup... so I need to seal up the holes on the underside of the hood where the hood latch is so no engine bay heat gets sucked up in there... I know i've seen little plastic/rubber plugs that are made to fit in those two small holes... anybody have a clue?

_JB_

iTrader: (33)

Look up the JAMM kit. I believe it's the only kit still in production to seal the hood.

Soul TKR

iTrader: (4)

well here's a pic of the JAAM kit... I'm not talking about sealing the main entry way... in the pic below it shows the holes i'm talking about... I know I've seen plugs custom made for these out of some sort of plastic or rubber, but can't remember where...

Soul TKR

iTrader: (4)

I think I found where I saw them... it is a part that comes with the BGRA kit... I know the main kit isn't made anymore... not sure if these are a part that is or not...

_JB_

iTrader: (33)

Yes that was part of the BRGA kit, I have them on my car.

Soul TKR

iTrader: (4)

man i want that kit so bad