O2 sensor question (how many)
#2
TECH Fanatic
iTrader: (6)
Join Date: Jan 2007
Location: Ain't tellin'
Posts: 1,406
Likes: 0
Received 0 Likes
on
0 Posts
I believe it's 2. One on the front bank, and one near the cat. If it's setting a P-0420 code then the one near the cat is bad.
-Mike
-Mike
Last edited by Mgpeagle; 06-23-2009 at 02:28 PM.
#3
LS1Tech Sponsor
only 2 man...
1 before the CAT, and 1 after the CAT...
1 before the CAT, and 1 after the CAT...
__________________
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
06MonteSS / DiabLew Tune
2014 Camaro 2SS/RS - LS3, 6-speed manual, short-throw performance shifter, NPP dual-mode performance exhaust, 1LE front splitter, ZL1 rockers, Z28 Rear Spoiler, all paint-matched Red Rock Metallic, BMR strut tower brace, Cold Air Inductions cold air intake, Apex Motorsports, Inc. catch-can, Custom DiabLew Tune
www.diablewtune.com -- www.diablocustomtune.com -- www.diablocustomtunegm.com
#7
TECH Apprentice
Thread Starter
iTrader: (1)
Join Date: Jun 2007
Location: Pittsburgh, Pa.
Posts: 374
Likes: 0
Received 0 Likes
on
0 Posts
So when I run my Superchips paq bank 1 sensor 1 the voltage is going nuts and the trim never breaks 7% while bank to voltage runs steady and the trim is at 98%.