LS1\2\6 Intake manifold swap 2.2 23 JAN
#44
Yeah I may have to. It's about the same height as the stock housing (except the opsu doesn't thread in there). Does the ls6 mani sit fine on the valley tray if the opsu sensor is removed?
Thanks,
Mike
Thanks,
Mike
#46
parkave did your hood shut ok with the TBSS manifold? I have a line on one right now and I might use that over the speed master as it makes a little more low end power.
#49
good read for choosing a new intake manifold for the LS4. particularly the stock truck manifold making 1 less avg hp and more avg torque than the ls6 IM. maybe its the engine build or what. here's the link:
http://www.hotrod.com/features/1507-...ifolds-tested/
http://www.hotrod.com/features/1507-...ifolds-tested/
#52
Yeh im probably just gonna stick with the speedmaster conversion for simplicity sake. I just have to finish porting it.
#53
#55
I was going to disable dod but keep the connection in tact; the more I mess with the connector the more I think I will put the blank connector back and not plug anything in...
What did everyone do to get the leads better exposed?
What did everyone do to get the leads better exposed?
#60