96blackta

iTrader: (7)

I'm going to install full exhaust soon and was wondering what else I should get at meanwhile. Any recommendations on spark plugs, wires, 02s? Anything else I may as well get at?

OlMastaScrilla

iTrader: (3)

Poly motor mounts, Ngk tr55's, msd wires, o2's will be fine, you will need o2 extensions if running longtubes.

96formulabird

i just put e3 diamond fire plugs in and the headers with gaskets and my ory pipe. and i just put factory 7mm wires on it. no need for bigger wires at just bolt ons. 8mm would be ok, but not completly neccesary. thats all i used. good luck. What headers did you get? i installed pacesetter LT's back in march.

brucealmighty744

iTrader: (2)

Poly motor mounts?? What are those and why would I want to change them? Just curious since I too am about to install LPPs and a GMMG.

OlMastaScrilla

iTrader: (3)

There stiffer motor mounts than stock. The ones you have (stock mounts) are going to be old and worn which may cause the headers to hit in some places (did on mine atleast) the poly motor mounts solved the issue. Since he is about to start a header install this is a good time to get at them.

killagt

iTrader: (3)

e3 plug any good ?

Z28_LT1

iTrader: (2)

i just got got ngk iridiums....um u may or may not need to get a new coolant pressure since you may break it during the driver's side install, im just giving u a heads up cuz i just did. anyway. good luck.

96formulabird

e3 plugs are the best i found so far. dont got to gap em or anything. i have had 3 set of plugs in my car and these are the ones i like the best. car runs a lot smoother too. i also have them in my trucks too. work great.

Revelation Z28

iTrader: (10)

my passenger side header hits the motor mount pedestal, so polys would've fixed this i bet.

96blackta

iTrader: (7)

I ordered the Texas Speed 3" cat-back, and will ordering either the ceramic-coated or painted LT Pacesetters with ORY.

I think I'll probably go with the MSD wires and tr55s. Any suggestions on front 02s? I want to replace them while doing the headers install.

litch2004

iTrader: (1)

The painted will burn off. If you get the ceramic coated you have to make damn sure to get all the grease off before firing it up. Maybe it is just bad luck around here but everyone that i have seen that have installed ceramic coated have flaked off.

If you can afford the extra $ my suggestion would be the jett hot coated. That is what i have and have yet to have a problem.

96blackta

iTrader: (7)

Maybe I'll just get the painted. What do I care if the paint flakes off?

litch2004

iTrader: (1)

just a cosmetic thing. They will just get rusty. I just like mine to look clean inside the engine bay.

OlMastaScrilla

iTrader: (3)

Go with the oem Ac Delco o2's if you want to replace them. As for the coating it does keep the temps down and they look much better. I have the painted ones but definately wish i had spent the extra money for coated ones. But I figure I will just spring for some kooks later down the line.