z28master

Just bought a nitrous kit for 95 z28 followed instructions step by step have stock motor so i just put 100shot setup (jets) and when i flip the switch it does activate just enough to waste my juice but absolutly no power gains. what have i done wrong or didnt do at all? BY THE WAY I HAVE SHOT A 10LB BOTTLE WORTH SINCE HOOKUP JUST TRYING TO FIX IT

z28master

By the way before anyone gets excited about my username lol it is only thing i could think of that was not already taken and that i could remember, guess i need to change now

Nomind

Don't suppose that you could shoot a quick picture of how you have the nozzles in the intake?

RamAir95TA

iTrader: (2)

What else have you installed (individual components)? You're leaving your problem very open-ended.

z28master

Cant at the minute, not with the car i had the port running into the cold air and thought that was my problem so i bought a plate and still the same i could post one tomorrow. Thanks for fast reply

z28master

Just standard hookup instead of hooking up switch under gas pedal hooked up at throttle?

z28master

Nomind i meant i cant post one at the minute im at in-laws house car is at home

Nomind

I would be concerned about where the N2O is going, if you don't feel anything when you activate it, and you've used a whole bottle. Sounds like it's venting into the atmo, somewhere.

keeven1320

u need to check the fuel side, n2o wont make power with out fuel, try flowing just the fuel side of it in to a bucket or something

z28master

Thanks again for all the help I will definatly look a little deeper tomorrow an find out what's goin on

brucer

i have always checked the fuel side first, actually dont even worry about the nitrous solenoid until i know for certain the fuel side is working first..