Tbird232ci

iTrader: (4)

This spring, I'm going to be getting my ram air hood painted, and doing the LS1 lid swap. I've searched and read, but I'd love to see just a bunch of pics of the swap. Want to get excited and motivated.

Z28Camaro30Ann

iTrader: (15)

Go here...

http://s1107.photobucket.com/albums/...0Modification/

93QWKZEE

iTrader: (13)

Here is mine I still need a silicone coupler.My car is 93 so no maf sensor but you get the point.

VinR1

iTrader: (17)

93QWKZEE, what coupler were u planning on using? I also have a '93

myltwon

iTrader: (1)

here's mine




didn't have to modify anything but did remove the ram air baffles

93QWKZEE

iTrader: (13)

most likely i will order a 4" silicone 4 ply but it has to be roughly around 8 to 9 inches long so i will order a 12'' piece and cut it down to size!

93QWKZEE

iTrader: (13)

I know my lid looks off alignment with the engine but believe me it's spot on center. Its just the angle of the crappy pic I took.

Black94Z28

iTrader: (12)

On my Camaro with my old setup. But I can say I was the first to run a full LS1 lid/base on a LT1 Camaro front end. Ran a Glastek 4 inch cowl hood. Still have my LS1 lid setup but now running a LS1 SS front clip...

Back with the LT1 front end, a little nasty looking, but I cleaned it up later...



Pic when I was doing the clip swap...



What it looks like now...just with an alternator though...

93QWKZEE

iTrader: (13)

^ I like it,I wonder why lol... great minds think alike! I must say your build thread inspired my build alot thanks Black94z28

quik95lt1

iTrader: (7)

i ran the FTP 104mm LID with some 4" plastic pipe from home depot lol.....and the chrs1313 ram air in front

Black94Z28

iTrader: (12)

Thanks! Means alot!

Tbird232ci

iTrader: (4)

Thanks guys! I got the base from the junkyard, so now I just need to work on selling off some stuff, and keeping my eyes peeled for a lid, and bottom feeding ram air setup.

ks my ss

here is mine so far

chrs1313

iTrader: (24)

nice times and setup...just need to work on the 60ft and you are golden for 9s

BADHAWK51

iTrader: (1)

Mine.

defaultexistence

iTrader: (11)

Ebay stainless lid with nitrous bungs

idformula

^
Did you get that bird tb plate off fleabay too? When I get to doing mine, I'm gonna swap the rad base too, I think it looks a lot cleaner when it looks factory like Blsck94z28's.

defaultexistence

iTrader: (11)

Yup'

slomarao

iTrader: (6)

Man now i want to swap to the 104mm Lid. The stock one seems small now after looking at pics....

idformula

How bad would the 104mm lid hit the stock hood, I know that I need to clearance the stock hood, but how much more would the 104mm take?