Anybody pull this off before....Whoopss!!!!!
#1
Anybody pull this off before....Whoopss!!!!!
Apparently I had a couple of shaft bolts back out on my jesel setup.......the result was snapping a tool steel rocker shaft clean in half........luckily it was at low rpm and i shut it down before it created any other damage to the motor........
#6
yep everything can break..........and yea me too!!! lol
#7
I had that happen to me once, when I first installed the shafts, I tried removing and installing the shafts w/o undoing the lash, it worked but had one shaft break similar to yours. I had my local machinist just make me a new one with the same material, never had a problem after. Later Clint
Trending Topics
#8
I had that happen to me once, when I first installed the shafts, I tried removing and installing the shafts w/o undoing the lash, it worked but had one shaft break similar to yours. I had my local machinist just make me a new one with the same material, never had a problem after. Later Clint