Bigtoyz

iTrader: (2)

I am wanting to setup my IAT sensor to my LM1 does anyone know or have the temp(ohm) to volt conversion to make it work? I have the excel from their site but dont know what it is made form to figure it out.

Any help would be appreciated.

shbox

The IAT resistance vs. temp is the same as what is in this chart.

Valkyn

iTrader: (8)

http://www.injuneer.com/ScanMast.html#step%208

There is a table for the coolant temp sensor on this page. If you read the last line of the Air temp sensor section it says that the ATS uses the same table.

Bigtoyz

iTrader: (2)

thats alot for the info guys. Been looking for that info along time.

Bigtoyz

iTrader: (2)

I got to looking in the logworks, but all I have to do I think is get a couple volt readings to get it from ohms to volts or am I wrong in that thinking?

Bigtoyz

iTrader: (2)

got it figured out but thx