You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join LS1Tech.com today!
97 z28 stock valve covers with a oil fill tube. A small amount of oil is leaking on top of the valve cover at the bottom of the oil fill tube. I am guessing its not on tight or the seal is bad? I've never took valve covers off, but it looks really simple, should I take the valve cover off and figure out whats going on?
__________________ 1997 Z28 M6, Ported & Polished Heads, Cam, RR, SLP Mid-Length Headers, Borla Exhaust w/Electric Cut-Out,SLP LS1 Lid Conversion, Electric Water Pump, Double Timing Chain, 42LB Injectors, Comp Push Rods, PCMFORLESS Tune, MSD Distributer and OPTI, Full Spohn Rear Suspension, Moser 12 Bolt w/4:10 gears
I've notice my '95 Is doing the same thing. When I bought her the dumbass before me placed a rubber cover over the filler neck instead of an oil cap(which I've now replaced.)
If that wasn't the cause of it, then what is? Good question.