full wire tuck from engine bay
#4
On The Tree
iTrader: (1)
Join Date: Feb 2010
Location: winnipeg, mb, canada
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
Im not too sure yet it all depends if i keep the stock nox or run a new box to clean up some of the unwanted things i. The car but i was thinking behind the glove box where i can get to it from the underside but i still need to put the dash in place first to see where is good.
#5
Staging Lane
Thread Starter
Join Date: Jun 2012
Location: sac
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
I got all the wire to the fuse box on the inside bolted u under dash. It was a bitch to get it to fit between the pedal assembly and the metal above it.. I cut some metal out and tucked it up. U should cut out as much wiring as possible so u dnt run into that problem I just don't know wiring like you.
Trending Topics
#10
Staging Lane
Thread Starter
Join Date: Jun 2012
Location: sac
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
See how much I hate wiring. I didn't even think of that that's like a slap in the face I should of thought of it. I think I didn't cause I only started doing the wire tuck cause blew tranny and got it back sooner than I thought im ready to drive it see how thus level 2 trans is.
#12
Staging Lane
Thread Starter
Join Date: Jun 2012
Location: sac
Posts: 75
Likes: 0
Received 0 Likes
on
0 Posts
Tuck the wires that have to be on motor better and vette covers then the other wires in my inner fender and under dash. Unless u have a better way that i haven't figured out lol
#14
On The Tree
iTrader: (1)
Join Date: Feb 2010
Location: winnipeg, mb, canada
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
my engine harness I depinned and ran all the wires to the back of the motor and extened the wires so I can mount the pcm inside the car which will go thru the fire right behind the motor to hide all the wiring, Im hopping the injector wires I had loom up will look ok. I havnt put my harness on the engine yet after it was finished.
#16
On The Tree
iTrader: (1)
Join Date: Feb 2010
Location: winnipeg, mb, canada
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
The plan is to put the harness on the motor this weekend and install the motor so ill have some pics for the install once its done, i hope i can get it done this weekend cause a big snow fall is heading our way and i dont want my car to be stuck in my yard lol