Triple Gauge Pod
#1
12 Second Club
Thread Starter
iTrader: (2)
Join Date: Jan 2011
Location: Old Bridge, NJ/Corpus Christi, TX
Posts: 1,216
Likes: 0
Received 1 Like
on
1 Post
Triple Gauge Pod
Sometimes having a hardtop LT1 bodied car proves to be a pain in the ***. I am in search of a pillar mounted 3 hole gauge pod (Eboost2, Wideband, Fuel Pressure). I have found stuff for t-tops and verts but not hardtops. Anyone have any suggestions?
Trending Topics
#11
I have a 94 hard top as well, search all over for triple gauge pod. I'm taking a double and single and will probably fiberglass them to the factory pillar.
The triples that I've seen are for the 97 and up dash.
The triples that I've seen are for the 97 and up dash.
#16
I used a US speed triple pillar and purchased a factory GM drivers a-pillar. Took both item and made on full triple drivers a-pillar, covered in black alcantara and it fits perfect. If I was going to make one again, I'm sure I could make it much easier the second time around
Last edited by 96silverram; 12-02-2012 at 08:35 PM.
#18
TECH Fanatic
the do not make a tripple for 93-96 specific. Heres mine 97-02 tripple. Had to do some trimming on the bottom but big whoop
https://ls1tech.com/forums/picture.p...ictureid=41525
https://ls1tech.com/forums/picture.p...ictureid=41525