hokeplaya05

iTrader: (3)

couple updated pics of my car, plati dipped the hood until I can get the car painted and also installed a spintech 2OTL catback this spring

n2oblkz

iTrader: (1)

^^^Uh....we need some sound clips of the Spintech 2OTL^^^

hokeplaya05

iTrader: (3)

I will try to get something tomorrow, been meaning to all summer just never had a chance

smitty2919

Looking forward to the sound clip

Toronto LT1

iTrader: (2)

CamaroWhoopAss

iTrader: (1)

That's an interesting car club up there; a classic, an f-body, an old beemer, FERRARI (wtf), brz/bzr.

hokeplaya05

iTrader: (3)

here is the exhaust clip as promised

hokeplaya05

iTrader: (3)

the BMW is my buddies car, rest are people I don't know lol was at a small local car show

n2oblkz

iTrader: (1)

Thanks for the clip, that sounds great.

hokeplaya05

iTrader: (3)

thanks man! I love it over the magnaflow that was on the car, very quiet and tame with no drone while cruising around and then really wakes up when you get on it.

camar0corey

iTrader: (22)

^Car sounds awesome and I like the way it looks! I'm torn on wheels down the road, I've thought about going the route you did, versus doing Fiskes or whatever. RTS look good!

hokeplaya05

iTrader: (3)

thanks! I love the welds, I just suck at keeping them clean lol they need to be cleaned and polished really bad which I will be doing this winter when they come off for storage.

2JAWZ

iTrader: (1)

Sounds really good, I like it. Also, your car has a great stance. Can't wait to see it once you get it all painted up. It's gonna look awesome.

hokeplaya05

iTrader: (3)

thanks man, you and me both!

n2oblkz

iTrader: (1)

Mine while out for a fall drive

rynb15

Got her polished and waxed. Also got a borla cat back installed. Sounds way better

JBIRD23

I'm new to this site so still getting use to this. I recently replaced the heads and head gaskets to a T/a due to a blown head gasket . Now The car turns on perfect but when it hits its temp it starts smoking from the exhaust manifolds. I've worked on carbed, tbi, vortec, and ls based engines but hardly any lt1's. so any advice would be appreciated.

hokeplaya05

iTrader: (3)

to start off, this is a multimedia/picture thread so not the place to be asking tech questions. go back a page and you'll see the tech section of the lt1 forum and you can post your question there. but to save you some time, sounds like there is probably some excess coolant or oil on your manifolds that is burning off from the gasket change. just run it until the smoking goes away.

C450

TwoFast4Lv

iTrader: (8)