BizZzatch350

iTrader: (33)

My IAT sensor wont fit in to the hole, any one else have this problem?

HBHRacing

it might help if you listed which elbow you are referencing.

transam5.7lt1

iTrader: (18)

I bought one off ebay and it did fit perfectly, it was made by a company named CRT Performance......

95FbFormula

iTrader: (25)

If you have a CAI just relocate it closer to the filter anyway. I have a Moroso CAI and have removed my A.I.R so i put the IAT in the spot were the AIR hose goes into the intake. or use a step bit and drill it out a bit. your choice.

BizZzatch350

iTrader: (33)

unknown brand

Schweet97Z

iTrader: (35)

take alittle wd-40 and lube up the rubber gromet. it will slide right in lol

thesoundandthefury

iTrader: (3)

Awhile back I had one of those generic "no name", (or so I thought), brand aluminum elbows off Ebay. Turns out it was a Granatelli. Had casting flash inside of the IAT hole. (Actually, the whole elbow was **** poor quality casting, which is why I didn't have it too long.) I just ended up grinding out the IAT sensor hole with a carbide burr. Wasn't a big deal really.