87Lt1Monte

iTrader: (1)

Ok, Im using 383 LT1, solid roller 236 242 550 550 lift, Victor E Intakew/ rails, intakeelbows elbow with 58mm tb and a 150 shot of juice. heads flow like LE2 maybe 3. in a 3200 lb car ran before that whats in my sig.. what you guys think?

-PEPE-

iTrader: (10)

I'd say you'd be in the low 11 to high 10s especially with your weight, sounds like a nice combo you have.

MEAN LT1

iTrader: (2)

Looking good so far. Whats your dcr and scr going to be?.

daniel6718

iTrader: (36)

good 60 foot...but id say with me being cam only no spray and around 3400 pounds street car...running 12.0x in 105 heat...you should be alot faster...maybe low 10's

Speed Density

iTrader: (38)

Im calling 11.20s-10.80s!!!

Good luck

Jditlfm

iTrader: (26)

Are you using the LPE 219 219 Cam or the 236 242, if you are using the Lpe cam those are outstanding numbers, if you have the 236 242 cam you should be faster like everyone is saying.

87Lt1Monte

iTrader: (1)

My sig has all old times with the 219 219 525 525 lift, i went through MD emissions and the next day ran that time no change dual cats and everything .. im getting it all ready to go.. just waiting for UPS to deliver my Intakeelbows.com elbow and i dont have the plate kit yet but i have all the solinoids and stuff from NX im using from a GM single nozzle kit. FJO Controller should be ready to ROCK right before winter comes I dont know what to expect . u think it will do high 10's no juice ??? ohh and the compression is staying the same 11to1

Jditlfm

iTrader: (26)

sounds like its gunna be a bad bitch.. I forsee High 10's low 11's without the juice.

87Lt1Monte

iTrader: (1)

I just found out that the cam is 236 244 590 590 lift ! its specs at 549 with 1.5's hope is FLYS !

Speed Density

iTrader: (38)

Thats a nasty cam.

87Lt1Monte

iTrader: (1)

I just want to run bottom 10's .. then ill just want to run 9's .. never ends