Phantomhp

iTrader: (7)

Ok, so I found the size of all the bolts for my LT1 intake but there are 4 bolts that are stud type.

Are those needed for anything or could I just put regular bolts in their place?

Thanks,
Mike

foggedz

iTrader: (1)

As long as you have eliminated the things that mounted off the studs you will be fine. I believe that the alternater bracket mounts to the 2 of the passanger side studs, and I think a coolant line also. On the drivers side part of the egr setup mounts to one of the studs.

LT1MAN

iTrader: (6)

doesn't the fuel rail bolt to the top of the studs too?

foggedz

iTrader: (1)

I dont think so. The fuel rail bolts to the top of the intake manifold

NotACop97Z

iTrader: (7)

He's Right, the largest Stud is for the alterator,

WhyHelloOfficer

iTrader: (5)

There is also a stud that holds some of the EGR/AIR equipment in place. One of the studs on the driver's side holds the throttle cables in line so that they line up to the throttle body for the throttle position and cruise control.

The LT1 That Could

iTrader: (3)

Hey Mike! I thought about this today...might call Scoggin and see if they have a set of LT1 Intake Bolts, they might have a full kit of the hardware needed.

the_merv

iTrader: (88)

Mine has a black Bracket with 3 Bolts to hold them.