Feast your Eyes....My LE3 Stage 3 Heads and Intake
#1
Feast your Eyes....My LE3 Stage 3 Heads and Intake
Here are a few pics of my heads and intake from Lloyd Elliot along with my stroker kit. My pistons are being plasma coated for Nitrous. The crankshaft, rods and pistons, flywheel and fluid dampener are all being balanced. I have my Holley 58mm on the way. Just need to get my Headers and my clutch and m trans back + a fresh tune and I'll be ready to go. 30 days and counting. Thanks Lloyd Elliot for all the good work. I'm gonna put this LT1 to work.
#3
I went with the LE4 cam. I am hoping 450+whp all motor. Low 11's all motor possibly 10's all motor. Nitrous is a given for 10's. I will be shooting a 300 shot+. I originaly went with the LE3 cam but Lloyd forgot my original plans of a fully forged 355 fully balanced high rapping motor. But I know what I have to do in order to beat a LS1 heads and cam motor. So I went with the 396 for the balance of torque and horsepower. Lloyd did not know that i was going 396 and he told me I will make even more power with his LE4 cam with the stroker kit over the LE3 cam. This is going to be a 700+ whp motor on Nitrous. Should give a Supra a run for his money. Dont mind the pics fellas.... the camera I have does these heads no justice for what they look like in person or perform.
Last edited by ZEX-Z; 05-14-2007 at 10:57 PM.
Trending Topics
#10
Launching!
Join Date: Apr 2007
Location: At your moms house
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by ZEX-Z
Thank you. I still have a lot of work to do. I recommend Lloyd to anyone. This motor will be a freak of nature, and a freak of LE.
#13
11 Second Club
iTrader: (88)
Originally Posted by ZEX-Z
Hah! Damn right! LS1's beware.... LS2's beware... LS6's, LS7's beware. Ahhhh............Gonna be nice.
Give me a 300 shot when I am done and I'll break my Camaro..
Nice stuff there, looks good. Get it built.
#16
TECH Fanatic
iTrader: (6)
Originally Posted by Ls1Bait
Looks great.........
BUT DUDE, you set the heads right on your SPOILER
BUT DUDE, you set the heads right on your SPOILER
i would love to see some good close ups of the exhaust ports if you dont mind. my heads were done by Eric Parish, and they look to be about like those as far as i could tell up around the valve stem. i would love some close ups though. your **** is going to be BIIIIIIIIIIIIIIIIIG NAAAAAAAAAAAAASTY son, BIIIIIIIIIIIIIIIG FUUUUUUUGGIN NAAAAAAAAAAAASTY!!!
#20
It was done very carefuly..... no scratches. Believe me. I will post some of the exhaust ports as soon as I get some better pics. I will have my block back and my stroker assembly this week and I will post some pics of the motor after it is put together. Dont worry about the spoiler...... the heads loved the spoiler.