View Poll Results: which muffler with mufflex
Spintech
11
68.75%
Flowmaster
5
31.25%
Voters: 16. You may not vote on this poll
Which muffler with mufflex?
#6
IMO the 4 in mufflex sounds to raspy with any type of muffler. But, with the spintech it sounds 10x more raspy than most other mufflers. A friend of mine had a spintech on a 4 in mufflex exhaust, and hated it so much it didnt last more than a few trips before he pulled it off.
Trending Topics
#11
That's MISTER MODERATOR
iTrader: (9)
Mufflex installed their 4 inch system in my car with the Spintech muffler. It sounds OK outside but horrible inside. I can't wait to change over to Kooks true duals. I just can't afford it now, I was planning a new shortblock this winter but the tranny in my work van died and that takes the priority.
The Mufflex system hits everything and the muffler is hung waaay too low, it could've easily gone higher. They didn't do a very good install. At one point, the muffler and entire rear section dropped off the hangers and I had to re-work it all.
My car came to me with the Edelbrock cat-back system. I think it sounded better than the Mufflex/Spintech system. Of course, it wasn’t as loud.
The Mufflex system hits everything and the muffler is hung waaay too low, it could've easily gone higher. They didn't do a very good install. At one point, the muffler and entire rear section dropped off the hangers and I had to re-work it all.
My car came to me with the Edelbrock cat-back system. I think it sounded better than the Mufflex/Spintech system. Of course, it wasn’t as loud.
#12
On The Tree
Join Date: May 2005
Location: Catawissa PA
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
I run the 4" - spintech single out. Spintech is slightly quieter and deeper then the flowmaster. I race at Englishtown and there is a noise limit, Dennis told me the spintech will pass, the flowmaster will not and I've never had a problem there with it.
Mufflex built my entire exhaust. Jethot LTs in to 3" Y-pipe with race cats that merge into a 3"in/4"out collector then 4" back to the single out spintech. I've gotten nothing but compliments on the sound of my car. Twice I've had cops come over to me and compliment the car?
Mufflex built my entire exhaust. Jethot LTs in to 3" Y-pipe with race cats that merge into a 3"in/4"out collector then 4" back to the single out spintech. I've gotten nothing but compliments on the sound of my car. Twice I've had cops come over to me and compliment the car?
#13
TECH Veteran
iTrader: (23)
Hers mine with a Mufflex and a Magnaflow 4 inch with a single tip
http://www.youtube.com/watch?v=0WConSQhjd0
http://img532.imageshack.us/my.php?image=launchqx7.flv
David
http://www.youtube.com/watch?v=0WConSQhjd0
http://img532.imageshack.us/my.php?image=launchqx7.flv
David
#14
TECH Fanatic
iTrader: (14)
Hers mine with a Mufflex and a Magnaflow 4 inch with a single tip
http://www.youtube.com/watch?v=0WConSQhjd0
http://img532.imageshack.us/my.php?image=launchqx7.flv
David
http://www.youtube.com/watch?v=0WConSQhjd0
http://img532.imageshack.us/my.php?image=launchqx7.flv
David
#15
Staging Lane
iTrader: (7)
Join Date: Nov 2004
Location: Edmond, OK
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
I've got a single chamber Flowmaster, 4 inch in, and 4 inch out. On long tube headers, dual 3 inch to the 4 inch. Sounded like the 4 horse men of the apocalypse, little to no rasp. I'd post a sound clip, but the car is down for a build up.
#16
I have a 3.5" in/dual 3" out Spintech. I don't think it sounds raspy at all, although the cats did soften the sound a bit. I've gotten a lot of complements on the sound. It looks good also. :-)
#17
TECH Veteran
iTrader: (23)
http://www.youtube.com/watch?v=1vNTW...eature=related
COntact these guys
www.fulllineexhaust.com
Here are the race series Magnaflow muffs
http://www.fle-online.com/cgi-bin/sh...owMufflers.htm
David
Last edited by FASTFATBOY; 12-09-2007 at 09:23 AM.