Trans hitting floor pan in reverse once torque arm was relocated, anybody else?
06-10-2008, 11:29 AM
#1
Trans hitting floor pan in reverse once torque arm was relocated, anybody else? This is on the 93 formula -OK, its not the brand that matters, I've tried Spohn and UMI, but each time I've installed the non-tranny mounted torque arms, the tranny hits the floor pan in R on the 6spd manual car.
It doesn't hurt anything, just annoying. When we pulled the trans out for rebuild you could see up in the shifter area where it is hitting.
Other than a quarter panel respray, the car hasn't been damaged or in a collision, so I can't figure it out.
Anyone else? If so, how to fix this?
It doesn't hurt anything, just annoying. When we pulled the trans out for rebuild you could see up in the shifter area where it is hitting.
Other than a quarter panel respray, the car hasn't been damaged or in a collision, so I can't figure it out.
Anyone else? If so, how to fix this?
