GOT MY NEW TRANY TR6060 (T56 Magnum)
04-20-2012, 09:16 AM
#141
TECH Apprentice
iTrader: (2)
Join Date: Jul 2004
Location: Mission, TX
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
got my new trany in. it is bad ***. i got it from D&D. great guys. only problem is that i think there was a misunderstanding when i ordered it. i wanted a 2.66 first gear. and i got a 2.97 first gear. but the great guys at D&D are sending me a new one with 2.66 gears. and then i am sending mine back.
03-18-2015, 09:20 AM
#142
On The Tree
Join Date: Nov 2012
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
mounting points Hi all
I want to use a t56 magnum for my bmw swap. There is a mounting kit out there for the t56 so I am wondering if the mounting locations are the same or if I will have to make new mounts. I figured you guys would know from your exploits in fitting one in your cars.
I want to use a t56 magnum for my bmw swap. There is a mounting kit out there for the t56 so I am wondering if the mounting locations are the same or if I will have to make new mounts. I figured you guys would know from your exploits in fitting one in your cars.
03-18-2015, 11:29 AM
#143
Staging Lane
Join Date: Jun 2006
Location: Medford, OR
Posts: 93
Likes: 0
Received 0 Likes
on
0 Posts
03-21-2015, 06:24 PM
#144
On The Tree
Join Date: Nov 2012
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
03-25-2015, 12:17 AM
#146
On The Tree
Join Date: Nov 2012
Posts: 152
Likes: 0
Received 0 Likes
on
0 Posts
there is a swap kit for both the I6 and V8 subframes in the 5 series, but both have tranny mounts for the t56. I know the shifter location is different on the magnum but I am wondering about mounting location. Will call tremec. I keep forgetting to do that.
03-21-2016, 11:25 AM
#148
An update to this thread incase others are finding it.
I talked to Tremec this morning and they referred me to Hanlon Motorsports, 610-469-2695, ask for Bob.
Have all of your information concerning your shifter issues (i.e. measurements, clocking, etc).
After talking to him I will be getting my Tremec shifter modified/machined for a 2" 90 degree offset clocked at the 7 o'clock position. But, I have to get photos/measurement to him this afternoon.
The cost is very fair considering all of the other options out there for offset shifters...
I talked to Tremec this morning and they referred me to Hanlon Motorsports, 610-469-2695, ask for Bob.
Have all of your information concerning your shifter issues (i.e. measurements, clocking, etc).
After talking to him I will be getting my Tremec shifter modified/machined for a 2" 90 degree offset clocked at the 7 o'clock position. But, I have to get photos/measurement to him this afternoon.
The cost is very fair considering all of the other options out there for offset shifters...
