LS1TECH - Camaro and Firebird Forum Discussion

Manual Transmission T56 | T5 | MN12 | Clutches | Hydraulics | Shifters

Trans member mounting hardware

Thread Tools
 
Search this Thread
 
Old 07-22-2009, 05:10 PM
  #1  
10 Second Club
Thread Starter
iTrader: (10)
 
BassProCamaro97's Avatar
 
Join Date: Jun 2007
Location: Wauconda IL
Posts: 510
Likes: 0
Received 1 Like on 1 Post

Default Trans member mounting hardware
I need mounting hardware for a T56 cross member. Does any one know the sizes of the mounting bolts or where I can get some quality replacment bolts?

Thanks,

~Jim~
BassProCamaro97 is offline  
Reply Like
Old 07-23-2009, 12:02 PM
  #2  
10 Second Club
Thread Starter
iTrader: (10)
 
BassProCamaro97's Avatar
 
Join Date: Jun 2007
Location: Wauconda IL
Posts: 510
Likes: 0
Received 1 Like on 1 Post

Default
I found out I need an M10x1.5 bolt.



~Jim~
Last edited by BassProCamaro97; 07-23-2009 at 12:16 PM.
BassProCamaro97 is offline  
Reply Like
Old 08-09-2009, 05:09 PM
  #3  
10 Second Club
Thread Starter
iTrader: (10)
 
BassProCamaro97's Avatar
 
Join Date: Jun 2007
Location: Wauconda IL
Posts: 510
Likes: 0
Received 1 Like on 1 Post

Default
Can any one tell me the length of the bolt?

M10x1.5xXXX????

All help is appreciated thanks.

~Jim~
BassProCamaro97 is offline  
Reply Like
Old 08-10-2009, 11:29 PM
  #4  
Teching In
iTrader: (2)
 
mikeagentorangeeornt's Avatar
 
Join Date: Aug 2007
Location: St. Louis, MO
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
Default
M10x1.5x25mm
mikeagentorangeeornt is offline  
Reply Like
Old 08-11-2009, 07:30 AM
  #5  
10 Second Club
Thread Starter
iTrader: (10)
 
BassProCamaro97's Avatar
 
Join Date: Jun 2007
Location: Wauconda IL
Posts: 510
Likes: 0
Received 1 Like on 1 Post

Default
Alright, thanks!!!!!

~Jim~
BassProCamaro97 is offline  
Reply Like
Back to Subforum
Manual Transmission
View Next Unread
sintered iron vs. cera-metallics, if you have experience w/ both step inside please




Advanced Search

All times are GMT -5. The time now is 10:43 AM.