pro 5.0 problem
#1
On The Tree
Thread Starter
iTrader: (1)
Join Date: Sep 2007
Location: long island
Posts: 157
Likes: 0
Received 0 Likes
on
0 Posts
pro 5.0 problem
so i had the tranny and clutch done on my car this past week (full rebuild on tranny and monster stg 2 clutch w/ lightweight flywheel). after i get the car back i realize that the shifter is dead to the left and right direction (no firm snapback to the center position, just falls where it may). does anyone have a parts diagram of the pro 5.0 or know what is the reason may be? are their springs in the shifter that hold it tight that might not have been put back on correctly? any advice would be appreciated. thanks in advance
#4
TECH Senior Member
iTrader: (35)
First remove the stick from the shifter, then take off the 4 Allen head bolts from the center section. The two parts(upper, and lower) should pop apart. You can install a small washer above each spring to give the springs more tension.
If you can find some stiffer springs to use, I'd like to know also.
If you can find some stiffer springs to use, I'd like to know also.