Throwout hydraulic line HEP!!!!
#1
Staging Lane
Thread Starter
iTrader: (6)
Join Date: Jun 2008
Location: Eureka, MO
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
Throwout hydraulic line HEP!!!!
I feel like a idiot but im pretty tired and using it as my excuse
Im trying to button up my build and all that is left is this one issue!
I had just finished up the wiring ( thanks the_MERV), a buddy jumped in the car went to push the clutch in and noticed it was like a brick wall, i forgot about the throw out bearing hydraulic line and cant figure out how to get the damn thing in! i have tried several methods and didnt know if any one could give me some help!
Also, i woudl think if the line was off, the clutch would fall to the floor.... not be hard. any explanations???
Im trying to button up my build and all that is left is this one issue!
I had just finished up the wiring ( thanks the_MERV), a buddy jumped in the car went to push the clutch in and noticed it was like a brick wall, i forgot about the throw out bearing hydraulic line and cant figure out how to get the damn thing in! i have tried several methods and didnt know if any one could give me some help!
Also, i woudl think if the line was off, the clutch would fall to the floor.... not be hard. any explanations???
#4
Staging Lane
Thread Starter
iTrader: (6)
Join Date: Jun 2008
Location: Eureka, MO
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
ok i still cant get this damn line, is it alwasy a pain in the ***???? it doesnt seem like something that should be complicated!
any suggestions will help, im stuck on this one!
any suggestions will help, im stuck on this one!
#5
TECH Resident
iTrader: (21)
Join Date: Feb 2005
Location: lakeland, fl
Posts: 834
Likes: 0
Received 0 Likes
on
0 Posts
give this a try my .02
Usually after you pull the line off the tranny a few times the o ring reshapes itself. It will look normal by eye but the o ring is to big to go past the fingers on the slave cyl quick connect. Take the rubber o ring off and see if it goes in without it. If it dont you have other problems if it does get a new o ring for the end of the line. DO NOT take off the white clip ONLY the o ring. If it goes in without the o ring you wil need to push in the white clip to get it back off.
LMK if this helps....
Usually after you pull the line off the tranny a few times the o ring reshapes itself. It will look normal by eye but the o ring is to big to go past the fingers on the slave cyl quick connect. Take the rubber o ring off and see if it goes in without it. If it dont you have other problems if it does get a new o ring for the end of the line. DO NOT take off the white clip ONLY the o ring. If it goes in without the o ring you wil need to push in the white clip to get it back off.
LMK if this helps....