stevo9389

after removal from my 94 formula the skip shift solenoid was physically damaged to the point that i would not be able to reconnect it to the pigtail. if i just have it (C.A.G.S./C.A.R.S) tuned out on the PCM would it cause a problem still if i left the sensor disconnected?

armyboyatc

iTrader: (29)

If you delete it outa the computer it shouldnt matter if its hooked up or not. My skip shift is unhooked and I havent had any problems.

ssjTAdriver

iTrader: (4)

Yes if the logic is no longer in the computer then you should not have to worry about it engaging the solenoid at any point. The light shouldn't even come on. Does it? GL.

stevo9389

thanks for the responses. just wanted to be sure i wasnt overthinking the issue.