MUSTANGBRKR02

iTrader: (91)

Well i am in the build up process on the t56. I am getting ready to put the main case back on but i am unsure if the 5-6 shift levers are installed properly. I had pictures of it before i took it apart but they are on a camera that my daughter broke. I am just not sure of the orientation of these levers. I looked thru the t56 build thread and i have the service manual and have read Joe Ambers write up but none of them cover this.

Thanks for the help.

Yes that is my kitchen table.

85MikeTPI

iTrader: (9)

The levers are in the proper position, though Rev lever is down for some reason and the engagement lever is up and out of the selector cam.

MUSTANGBRKR02

iTrader: (91)

Mike, how do i rearrange those to fix that?

Edit. think i got it. Is this correct? Also if so is the tranny in neutral now?

85MikeTPI

iTrader: (9)

Rotate the shift rail away from the selectors, then align the cam and select together. Then rotate the shift rail back into the selector slots and you should be good..

the_merv

iTrader: (88)

That should do it..

MUSTANGBRKR02

iTrader: (91)

Thanks guys. attached more photos above.

Merv. I have mine attached like Mike stated and now mine looks like his. In your pic they looked stepped in the cam